Aerospace Science and Technology
Majid Sedghi; Rouhollah Khoshkhoo
Abstract
This research aims to numerically investigate the efficiency of the plasma actuator in a small wind turbine. The studies were conducted on a domestic wind turbine with a diameter of 1.93 m and the Suzen-Huang model was employed to simulate the DBD plasma actuator. In this research, first, a wind turbine ...
Read More
This research aims to numerically investigate the efficiency of the plasma actuator in a small wind turbine. The studies were conducted on a domestic wind turbine with a diameter of 1.93 m and the Suzen-Huang model was employed to simulate the DBD plasma actuator. In this research, first, a wind turbine without the plasma actuator was simulated at different tip speed ratios. Then, the DBD plasma actuator was activated at a tip speed ratio of 4.35, and changes in the power output, torque distribution, and surface streamlines were studied. The results indicate with an increase in the power of the plasma actuator, the separation point moved away from the leading edge, the span-wise flows were reduced, and the turbine power output increased. The performance of the plasma actuator is varied along the wind turbine blade length. For the radii r/R=0.4-0.95, a difference in the generated torque can be observed for active and inactive plasma modes, and the plasma actuator did not significantly affect the power output in other sections. The maximum increase in torque due to the plasma actuator has occurred at the radii r/R=0.5-0.7. In these regions, the distance between the separation point and the plasma actuator location is about 0.2 times the chord length of the airfoil.
Aerospace Science and Technology
Bahareh Mojarrad; Saeed Oveisi; Mostafa Kazemi; Mahmoud Mani
Abstract
The primary objective of this study was to demonstrate how plasma actuators could be used to discharge a perpendicular dielectric barrier as a virtual Gurney flap. This study utilized wind tunnel experiments on a flat plate airfoil. Each experiment is conducted at two different free flow velocities of ...
Read More
The primary objective of this study was to demonstrate how plasma actuators could be used to discharge a perpendicular dielectric barrier as a virtual Gurney flap. This study utilized wind tunnel experiments on a flat plate airfoil. Each experiment is conducted at two different free flow velocities of ten and twenty meters per second. To study and extract the aerodynamic phenomena generated by plasma actuators and to compare them to the Gurney phenomena of a physical flap, velocity profiles in the model sequence were measured using a hot wire flow meter in two different longitudinal positions relative to the model. All experiments were conducted from five distinct vantage points, 0, 2, 4, 6, and 8, and plasma actuators were activated in two distinct settings to extract concepts under a variety of conditions. Wind tunnel experiments indicate that downward sequence transfer occurs when plasma actuators are used. Additionally, there are two distinct types of vortex shedding on the model's back: one that resembles Karman vortex shedding and another that occurs below the model. The observation of velocity profiles demonstrates that the deformation of the sequence caused by the use of plasma actuators is very similar to that caused by an airfoil sequence equipped with a physical Gurney flap.
