Aerospace Science and Technology
Mahyar Naderi; Liang Guozhu; Hassan Karimi; Sara Pourdaraei
Abstract
In order to reduce cost and time along with enhancing the safety issues, numerical computer modelling and simulations are widely used for analyzing complex systems such as launch vehicle or spacecraft propulsion system. The objective of this research is to obtain an algorithm for simulation of ...
Read More
In order to reduce cost and time along with enhancing the safety issues, numerical computer modelling and simulations are widely used for analyzing complex systems such as launch vehicle or spacecraft propulsion system. The objective of this research is to obtain an algorithm for simulation of staged combustion cycle liquid propellant engines. For this purpose the space shuttle main engine (SSME), as one of the world’s most complicated engines, is selected as a case study. A total of 34 elements is taken into account and using more than 100 linear/non-linear equations, the engine’s steady state system model has been established in MATLAB SIMULINK software. The simulation method uses eleven nested loops for iteration. The algorithm is based on the known parameters at the inlet of engine main feed lines namely mass flow rate and pressure, similar to the known conditions during hot test of engine on test stand. The simulation is capable of predicting the engine’s operation in wide range of thrust throttling levels from 69 percent to 109 percent of the nominal thrust. In order to validate the suggested method, SSME main component parameters, operating at 109 percent of rated thrust is presented. Simulation result mean error is less than 5 percent.
علی جعفرقلی; حسن کریمی مزرعه شاهی
Volume 10, Issue 1 , March 2013
Abstract
A new procedure for deriving nonlinear mathematical modeling for a specific class of aerospace hydro - mechanical control valves is presented. The effects of friction on the dynamic behavior of these types of valves along with the experimental verifictions are also given. The modeling approach is based ...
Read More
A new procedure for deriving nonlinear mathematical modeling for a specific class of aerospace hydro - mechanical control valves is presented. The effects of friction on the dynamic behavior of these types of valves along with the experimental verifictions are also given. The modeling approach is based on the combination of the following three tasks: decomposition of the valve into simple specific subsystems; derivation of the governing equations of each subsystem; and determination of the unknown parameters and coefficients using dynamic and static tests. Dynamic analysis shows that the presence of friction causes the hysteresis phenomenon in these valves and friction force increment causes an increase in the tracking error. On the other hand, excessive reduction of the friction force causes an instable performance. Therefore, a trade-off between the amount of tracking error and stability margins must be considered.
